Step
1. Connect
your side rails to headboard legs and insert 2 screws per leg. Now connect
your side rails to footboard legs using 2 screws per leg. Connections are
made on top most pre drilled holes for mattress only setting.
Step
2. Attach
bottom of black nylon support clips to your side rails. Insert steel cross
supports into black nylon clips. Run screws down through the top into
the nylon clip through the steel cross support. Make sure it's not quite in all the
way yet.
Step
3. Install your masonite panels down over the top of the steel crossbars.
Panels are lined up in the middle of each plastic clip and once installed
screws can be tightened down.
Step
4. Certain bed sizes use middle support legs and these are installed
underneath the steel cross bars of your bed. Your mattress may now be placed
over the support system and your new Amisco bed is ready for daily use.
